3D Printed electrical connectors for general use
 
Set of 50 electrical wiring connector which will raise level of detail of your model on the next level.
Kit contains:
- 10 connectors of A type – 2 holes on each side (dim. 1 x 1.7 x 3 mm)
- 10 connectors of B type – 4 holes on each side (dim. 1.7 x 1.7 x 3mm)
- 20 connectors of C type – 1 hole on each side (dim. 0.7 x 3mm)
- 10 connectors of D type – 4 holes on one side / 2 on the other (the same as B type).
- set of wires in 8 colors (approx. 13 cm each, external diam. 0.6 mm, wire diam. 0.25 mm)
- set of 2 shrink tubes, each in different size (approx. 10 cm long each)
Type C connector can be used to connect 2 wires as well as part of connector with smaller
diameter can be glued into previously drilled hope and then the connector can be used as cable joint
for example oxygen sensor or other ECU connections.
If needed color isolation from wires can be removed and then one can use thin wires (which
can be painted) for reproduction of multi wire connections. Holes in each connector (their size and
location) can be easily changed with the use of putty and drills.